Finishing An Unvented Attic

With unvented attics the air barrier vapor and thermal controls are installed at the roof deck.

Finishing an unvented attic.

The irc has permitted unvented conditioned attics since 2006 with certain requirements. An attic is simply the space between a pitched roof deck and the rest of the house. Coverage gaps could lead to moist outdoor air entry. Converting your attic into usable finished space can increase the value of your home by maximizing the available square footage.

This allows you to install your bulkheads above the ceiling plane without the need for spray foam insulation. This reduces latent air conditioning loads and provides further reductions in energy consumption. Residential unvented attics. The same conditions apply for moisture.

An alternate to spray foam insulation in an unvented attic is plenum trusses which allow you create a reverse bulkhead above the ceiling plane that is insulated. But according to energy star the average home loses about 20 percent of the air that moves through the hvac system due to. For unvented attics having the spray foam layer applied continuously from the roof wall intersection to the roof peak at the specified thickness encapsulating the entire interior surface area of the attic will hinder airborne moisture entry while providing an energy efficient environment. The roof deck in an unvented attic must be exceptionally airtight.

If your home is smaller than other homes in your area or simply lacks the necessary amount of storage or living space for your family finishing your attic is a relatively inexpensive way to increase your usable space. Code requirements vary across the country. By moving the vapor control layer to the roof deck it prevents moisture related problems. Traditionally we place hvac and ductwork and often storage up there and insulate the floor of the attic.